Saturday, August 28, 2021

New Secondary dwellings (granny flats) / Smithfield, NSW 2164

  The subject site is located on a quiet residential street, in the municipality of Fairfield City Council. The land has 656.7 square metres; with Approximate 20 metres is the main Frontage length and an Approximate 38.4 metres in depth. The existing Building on the Lot is a weatherboard cladding single storey dwelling House with a concrete Tiled roof. A garage is detached from the main dwelling. In the backyard, there is a covered area. The proposed land is generally flat.

 

EXISTING BUILDINGS ON THE SITE
Single storey weatherboard cladding house, with concrete tiled, pitched roof. It has 3 bedrooms, Living, kitchen, dining, laundry, one bathroom and a small toilet.  The existing dwelling has an outdoor covered terrace. It has a large garden area around the existing dwelling. The house is in good condition.
 
THE PROPOSAL
The proposal includes
1.    the erection of a secondary dwelling, a self-contained 60 square meters dwelling, established in conjunction with the main dwelling (the principal dwelling), and is on the same lot of land (not being an individual lot in a strata plan or community title scheme) as the principal dwelling, and is separate from, the principal dwelling. The secondary dwelling will have 2 beds with bathroom, kitchen, and dining and Lounge area.
RELEVANT PLANNING CONTROLS
a.           State Environmental Planning Policy (Affordable Rental Housing) 2009
This Development for the purposes of a secondary dwelling[1] is a complying development because the development has met the:
(a)  General requirements meet the general requirements for complying with development set out in clauses 1.17A and 1.18 (1) and (2) of State Environmental Planning Policy (Exempt and Complying Development Codes) 2008, and
 (b)  Land-based requirements is on a lot that does not include any land referred to in clause 1.19 (1) of that Policy, and
(c)  Specified development is on land in Zone R1, R2, R3 or R4 or a land-use zone that is equivalent to any of those zones, and
(d)  Is on a lot that has an area of at least 450 square metres, and
(e)  Does not involve the erection of a basement or alterations or addition to an existing basement, and
(f)  Does not involve the erection of a roof terrace on the topmost roof of a building or alterations or addition to any such existing terrace, and
(g)  Development standards satisfy the development standards set out in Schedule 1.
 



Schedule 1 Development standards for secondary dwellings
COMPLIANCE TABLE


Friday, August 27, 2021

Design A new double storey dwelling with detached secondary dwelling at EDENSOR PARK NSW 2176, Fairfield council

The site is a rectangle-shaped land. And it is a vacant lot. The surrounding dwellings comprise single-storey dwellings and double-storey dwellings. Adjacent to the rear is a vacant lot. Adjacent to the eastern boundary is currently a single storey house and adjacent to the western side is a vacant Lot too.

The proposed site has 582.5 with the front boundary of 19.66m & rear boundary of 19.66m, eastern side boundary of 29.63m and western side boundary of 29.63m. The Natural ground level near the frontage is (76.10), while it is (75.87-75.49) near the rear side.

The site falls softly from front to rear (south to north) then it falls very softly from side to side west to east, then it slops back to the street through the driveway.

The Land in zone R2, which is Low-Density Residential.

The frontage, on Edensor Park Road, is orientated towards the south (check the survey plan).  

 


4.0       THE PROPOSAL

The proposal is to construct two storeys dwelling with detached secondary dwellings at the rear. The dwelling will include 5 beds & a study room, a living & dining room and a family space upstairs. The secondary dwelling will include 2 beds with bathroom, kitchen, dining and living area.

5.0       RELEVANT PLANNING CONTROLS

5.1       LEP and land-use zoning

The subject site is within the Zone R2 – – Low–density residential. Dwelling houses are permitted subject to development consent within this zone.

The objectives of the zone are:

 

A.    To provide for the housing needs of the community within a low-density residential environment. To provide a variety of housing types within a medium-density residential environment.

B.   To enable other land uses that provides facilities or services to meet the day to day needs of residents.

 

It is considered that the proposed development satisfies all relevant zone objectives contained in the FLEP 2013 as follows:

1     A permissible form of development is being provided on an allotment of land that exceeds the minimum allotment size for dwelling house and secondary dwelling development;

2     Consideration has been given to the existing amenity and character of the area and it is considered that the proposed development is sympathetic and harmonious with adjoining development and will complement the existing character of the locality;

3     The proposed development will enhance the amenity of the residential area by the provision of new affordable residential accommodation and landscaping; and

4     The the development will add to the range of housing in the zone through the provision of an average size family dwelling with extended family facilities.

 

5.1.1    Height of Buildings (Clause 4.3)

The objectives of this clause are as follows:

1     To establish the maximum height for buildings,

2     To ensure that the height of buildings complements the streetscape and character of the area in which the buildings are located,

3     To minimise the visual impact, disruption of views, loss of privacy and loss of solar access to existing development.

The Height of Building Map categorises the site within the maximum 9m building height limit. The proposed dwelling house has a maximum height of 8.69m at the lowest natural ground level which satisfies the requirements of the clause.

5.1.2    Floor Space Ratio (Clause 4.4)

The objectives of this clause are as follows:

(a) To provide an appropriate density of development consistent with the established centres hierarchy,

(b) To ensure building density, bulk and scale make a positive contribution toward the desired built form as identified by the established centres hierarchy.

The FSR Map indicates a maximum FSR of 0.45:1 for the subject site which the proposal complies with, having an FSR of 0.45:1. In terms of bulk and scale, the proposed 2 storeys dwelling and the low scale secondary dwelling will be comparable to other already built dwellings in the locality.

5.1.3    Exceptions to development standards (Clause 4.6)

Consent may, subject to this clause, be granted for development even though the development would contravene a development standard imposed by this or any other environmental planning instrument. In this regard, NO variation requests are required as the proposal complies with all development standards contained in FLEP 2013.

5.1.4    Preservation of trees and vegetation (Clause 5.9)

The proposal does not involve the removal of any trees. New trees will be planted as indicated on the Landscape Plan which will enhance the future amenity of the site and locality.

5.1.5    Heritage Conservation (Clause 5.10)

The subject site is not listed as a heritage item or located near any heritage-listed items.

5.1.6    Bushfire Hazard Reduction (Clause 5.11)

The subject site is not identified as being in a bushfire prone area.

5.1.7    Acid Sulfate Soils (Clause 6.1)

According to the Acid Sulfate Soils Map, the subject site is not within a classification category known for acid sulphate soils to occur.

5.1.8    Flood Planning (Clause 6.3)

The site is not identified as on flood-prone land.  

 

5.2        FAIRFIELD DCP

The Fairfield DCP 2013 covers ‘Dwelling House’ development. The relevant planning principles outlined in the the plan has been incorporated into the design of the proposed development, resulting in an appropriate outcome for the site having minimal impact on adjoining and nearby development. All relevant numeric DCP requirements have been tabulated in the Control Table below:

DCP Controls

Requirement

Compliance

Lot size

Minimum 450M²

582.5M² - Complies

Floor space ratio

a)Maximum 0.45:1

b)Maximum  60 sqm Secondary dwelling.

The Maximum permissible floor space ratio for both, the principal dwelling and secondary dwelling combined must comply with the floor space ratio standards prescribed on the Fairfield LEP Floor Space Ratio Map.

From LEP , Proposed  lot within

C - 0.5 Ratio : Range [ 0.45 - 0.49 ] (pub. 2013-05-17)

 

- Complies.

 

Height (main dwelling).

 

 

Height (secondary dwelling).

 

Maximum 7.2 at eaves and 9.0m at the ridge. Maximum parapet wall is 8m

 

 

Maximum 4.5 ridge height

 

Highest ridge level is 8.69m and 5.8m to eave measure at the lowest natural ground level. – Complies

 

Highest ridge level is 4.44 –Complies

Front setback

Within 1.5 metres of

the average existing

front street setback

And a minimum of 4.5 metres.

f) Regardless of control (d),

 

and carport must be setback 5.5 metres from the boundary or the

Access handle.

The Proposed main dwelling front setback of minimum 6 m, compliance.

 

 

 

 

and 6 m from the garage door– compliance.

Side setbacks

Minimum 900mm

Proposed side setback 900mm western elevation and 4m eastern elevation – Complies

Building appearance

Address the street and front door to be visible

Complies

Vehicle Access Design & Driveway location

Minimise driveway

width and locate 1m

clear of power poles

Proposed double driveway width of 5.8m. – Complies

Garages and

carports

Not to be the dominant feature

 

Not more than 50% of Façade

 

Not more than 600mm forward of living areas.

 

Garage level no

greater than 300mm

above natural ground

No proposed garage - Complies

 

No proposed garage - Complies

 

No proposed garage - Complies

 

 

No proposed garage - Complies

Private Open Space

Main dwelling - Minimum private open space of 60 m2, with one area with min dimension 5m x 6m

 

Secondary dwelling 24M², with 4m dimensions.

Proposed 124M² with min. 5mx6m Complies

 

 

Proposed 24m² with min. 4m - Complies

Open space access

Direct access from the living area to private open space

Complies

 

Landscaping

30% soft soil zone

50% of soft soil in rear

50% of the front yard to be landscaped

Proposed 32% Complies

Proposed 167% Complies

Proposed 73% Complies

Solar access (subject site)

Living areas oriented towards north & to receive minimum 3hrs of sunlight

Living room on ground level and family on the first level oriented toward the northeast elevation which received 3 hrs of solar access.  Complies

Solar access (adjoining sites)

Not overshadow adjoining properties

The proposal is dwelling well set back from the boundaries so will not have significant impact on adjoining properties. Complies

Drainage

Plan required to

illustrate how property

will be drained or

provide Easement to

Drain Water

Refer to the included stormwater

Drainage plans. Gutters and

downpipes designed to drain into

rainwater tank and then from the

Tank to the street. Complies.

Site servicing

Water, sewerage,

electricity, telephone

and internet

Complies.

 

5.3.1    BASIX

On the 1st July 2004, the State government introduced BASIX, which consolidates planning provisions relating to water consumption and greenhouse gas emissions. A BASIX Certificate is provided with the application demonstrating the applicant’s commitments in achieving the objectives of the state government’s policy. The BASIX SEPP states in clause 8 and 9 that:

 

“‘competing provisions’ in an environmental planning instrument or Development Control Plan are of no effect about a residential development proposal required to be assessed by BASIX, ‘to the extent to which they aim:

(a) To reduce consumption of mains-supplied potable water, or reduce emissions of greenhouse

Gasses in the use of a building to which this Policy applies or in the use of the land on which

Such a building is situated; or

(b) To improve the thermal performance of the building to which this Policy applies.’”

It is proposed to install a rainwater tank as specified at the BASIX certificate to hold water for the proposed principal dwelling, to be used for flushing toilets, clothes washing and outdoor irrigation, which satisfies the requirements of the policy.

Energy conservation principles will be achieved through the construction method and orientation of the building, together with future thoughtful planting of trees and shrubs.

 

5.3.2    Internal Driveways

A relatively level site ensures that appropriate driveway grades can be achieved following AS 2890.2 - 2002. The Architectural Plans provide a driveway profile to demonstrate compliance.

 

5.3.3    Waste Disposal & Re-use Facilities

A Waste Management Plan will be submitted as a separate document to accompany the demolition application. The plan adopts the principles of Avoid Reuse Recycle and Dispose to minimise landfill waste.

5.3.4    Crime Prevention through Environmental Design

Design guidelines outlined in the Crime Prevention through Environmental Design (CPTED) were considered and incorporated as follows:

·         Provision of a clearly visible entry point facing the street;

·         Passive surveillance treatment has been provided through the provision of habitable rooms and a balcony which face the street;

·         Suitable landscaping will produce a defensible open space at the front, resulting in some interaction with the public domain beyond; and

·         Boundary fencing and gates will be provided to prevent intruders from accessing the private open space area.


We successfully got approved for the Multi Dwellings project at ( - ) OGILVY STREET PEAKHURST

FOR HURSTVILLE CITY COUNCIL/ 103 Architectural Design, documented, 3rd max and photomontage is done by Rana Jaber Proposed: Demolitio...